3Com 8807 Configuration Manual page 869

Configuring system password parameters
■
Configuring super password parameters
■
Deleting history password records
■
After the configuration, you can carry out display password-control in any view
to view the password control information for all users, including the
enabled/disabled state of password aging, the aging time, the enabled/disabled
state of the minimum password length limitation and the configured minimum
password length, the enabled/disabled state of history password recording, the
alert time before password expiration, the timeout time for password
authentication, the maximum number of password input attempts, the maximum
number of history password records, the processing mode after failed password
input attempts, the time when the password history was last cleared, and so on.
If a user fails to provide the correct password after the allowed number
login-times, the system adds the user to the blacklist. To view the names and the IP
addresses of such users, carry out display password-control blacklist in any
view.
Table 820 Basic configuration tasks of password control
Operation
Enter system view
Enter local user view
Configure system login
password
Exit the current view and
return to the system view
Enable password control
Configure system password
parameters
Configure super password
parameters
Delete history password
records of one or all users
Delete history records of
super password
Introduction to Password Control Configuration
Command
system-view
local-user username
password [ simple | cipher ]
password
quit
password-control { aging |
length | history } enable
password-control { aging
aging-time | length length |
login-attempt login-times |
history max-record-num |
alert-before-expire
alert-time |
authentication-timeout
authentication-timeout |
exceed { lock | unlock |
locktime time } }
password-control super {
aging aging-time | length
length }
reset password-control
history-record [ username
username ]
reset password-control
history-record super [ level
level-value ]
869
Description
-
-
Input the password twice as
prompted by the system,
ensuring the same password
is inputted at both time
By default, password control
is disabled
Refer to the detailed
description in the following
paragraphs about the
configuration of system
password parameters
The commands
password-control aging
aging-time and
password-control length
length can also be used in the
local user mode
By default, the aging time of
the super password is 90
days, and the minimum
length of the super password
is 10 characters.
-
-