3Com 8807 Configuration Manual page 47

Configuring Redirection
Table 25 Configure Modem attributes
Operation
Configure to permit call-in and call-out.
Configure to disable call-in and call-out
Send command
The following command can be used for sending messages between user
interfaces.
Perform the following configuration in user view.
Table 26 Configure to send messages between different user interfaces.
Operation
Configure to send messages between
different user interfaces.
Auto-execute command
The following command is used to automatically run a command after you log in.
After a command is configured to be run automatically, it will be automatically
executed when you log in again.
This command is usually used to automatically execute telnet command on the
terminal, which will connect the user to a designated device automatically.
Perform the following configuration in user interface view.
Table 27 Configure to automatically run the command
Operation
Configure to automatically run the command
Configure not to automatically run the command
Note the following points:
After executing this command, the user interface can no longer be used to
■
carry out the routine configurations for the local system. Use this command
with caution.
Make sure that you will be able to log in to the system in some other way and
■
cancel the configuration, before you use the auto-execute command
command and save the configuration.
# Telnet 10.110.100.1 after the user logs in through VTY0 automatically.
[3Com-ui-vty0] auto-execute command telnet 10.110.100.1
When a user logs on via VTY 0, the system will run telnet 10.110.100.1
automatically.
User Interface Configuration
Command
modem both
undo modem both
Command
send { all | number | type number }
Command
auto-execute command text
undo auto-execute command
47