Vrrp Configuration Example - 3Com 8807 Configuration Manual

660 C 53: VRRP C
HAPTER
VRRP Configuration
Example
VRRP Single Virtual
Router Example
ONFIGURATION
Table 601 Display and debug VRRP
Operation
Display the configuration information of the
VRRP-enabled IFM device
Display VRRP statistics information
Display VRRP summary information
Clear the statistics information about VRRP
Enable VRRP debugging.
Disable VRRP debugging.
You can enable VRRP debugging to check its running. You may choose to enable
VRRP packet debugging (option as packet), VRRP state debugging (option as
state), and/or VRRP error debugging (option as error). By default, VRRP debugging
is disabled.
Networking requirements
Host A uses the VRRP virtual router which combines switch A and switch B as its
default gateway to access host B on the Internet.
VRRP virtual router information includes: virtual router ID1, virtual IP address
202.38.160.111, switch A as the Master and switch B as the Backup allowed
preemption.
Command
display vrrp ifm
display vrrp statistics [ vlan-interface
interface-number [ virtual-router-ID ]
display vrrp summary
reset vrrp statistics [ vlan-interface
interface-number [ virtual-router-ID ] ]
debugging vrrp { state | packet | error }
undo debugging vrrp { state | packet |
error }