3Com 8807 Configuration Manual page 622

622 C 51: MPLS VLL
HAPTER
Configuration procedure
1 Configure PE-A.
# Configure the LSR ID. Enable MPLS, LDP, and MPLS L2VPN.
[PE-A] mpls lsr-id 192.1.1.1
[PE-A] mpls
[PE-A-mpls] quit
[PE-A] mpls ldp
[PE-A] mpls l2vpn
# Configure VLAN 212.
[PE-A] vlan 212
[PE-A-vlan212] port gigabitethernet 2/1/2
[PE-A-vlan212]interface vlan-interface 212
[PE-A-Vlan-interface212] quit
# Configure VLAN 21.
[PE-A] vlan 21
[PE-A-vlan21] port gigabitethernet 2/1/1
[PE-A-vlan21] quit
[PE-A] interface Vlan-interface 21
[PE-A-Vlan-interface21] ip address 168.1.1.1 255.255.0.0
[PE-A-Vlan-interface21] mpls
[PE-A-Vlan-interface21] mpls ldp enable
# Configure an IP address for the Loopback interface, which is used as the Router
ID.
[PE-A] interface loopback 0
[PE-A-LoopBack0] ip address 192.1.1.1 255.255.255.255
# Enable OSPF.
[PE-A] ospf 1
[PE-A-ospf-1] area 0.0.0.0
[PE-A-ospf-1-area-0.0.0.0] network 192.1.1.1 0.0.0.0
[PE-A-ospf-1-area-0.0.0.0] network 168.1.1.1 0.0.255.255
# Create an LSP tunnel.
[PE-A] mpls
[PE-A-mpls] quit
[PE-A] mpls ldp
# Configure the LDP Remote Peer.
[PE-A] mpls ldp remote-peer 1
[PE-A-remote-peer-1] remote-ip 192.1.1.2
# Configure a Martini MPLS L2VPN connection.
[PE-A] interface vlan-interface 212
[PE-A-Vlan-interface212] mpls l2vc 192.1.1.2 20