3Com 8807 Configuration Manual page 817

Table 767 Send the configuration information to the monitor terminal
Device Configuration
Enable information
center
Set the information
output direction to the
monitor
Switch
Set information source
Enable the terminal
display function and this
function for the
corresponding
information
4 Sending the configuration information to the log buffer
Table 768 Send the configuration information to the log buffer
Device Configuration
Enable information
center
Set the information
output direction to the
logbuffer
Switch
Set information source
5 Sending the configuration information to the trap buffer
Information Center Function
Default value
By default, information
center is enabled
-
-
-
Default value
By default, information
center is enabled
-
-
817
Configuration
description
Other configurations are
valid only if the
information center is
enabled
-
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information
For Telnet terminal and
dumb terminal, to view
the information, you
must enable the current
terminal display function
using the terminal
monitor command
Configuration
description
Other configurations are
valid only if the
information center is
enabled
You can configure the
size of the log buffer at
the same time.
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information