3Com 8807 Configuration Manual page 260

260 C 26: AAA
HAPTER AND
Setting the Unit of Data
Flows Destined for the
TACACS Server
Setting Timers
Regarding TACACS
Server
RADIUS/HWTACACS P
ROTOCOL
Perform the following configuration in HWTACACS view.
Table 237 Set the unit of data flows destined for the TACACS server
Operation
Set the unit of data flows
destined for the TACACS server
Restore the default unit of data
flows destined for the TACACS
server
The default data flow unit is byte.
Setting the response timeout timer
Since HWTACACS is implemented on the basis of TCP, server response timeout or
TCP timeout may terminate the connection to the TACACS server.
Perform the following configuration in HWTACACS view.
Table 238 Set the response timeout timer
Operation
Set the response timeout time
Restore the default setting
The default response timeout timer is set to 5 seconds.
Setting the quiet timer for the primary TACACS server
Perform the following configuration in HWTACACS view.
Table 239 Set the quiet timer for the primary TACACS server
Operation
Set the quiet timer for the primary TACACS server
Restore the default setting
The timer quiet command is used to make the switch ignore users' requests for
server within the time configured in this command in case the communication
between the switch and the server is terminated. In that case, the switch can send
users' requests to the server only after it has waited a time no less than the time
configured with this command for the communication to be resumed.
By default, the primary TACACS server must wait five minutes before it can
resume the active state. The time ranges from 1 to 255.
Setting a realtime accounting interval
The setting of real-time accounting interval is necessary to real-time accounting.
After an interval value is set, the NAS transmits the accounting information of
online users to the TACACS accounting server periodically.
Perform the following configuration in HWTACACS view.
C
ONFIGURATION
Command
data-flow-format data { byte | giga-byte | kilo-byte |
mega-byte }
data-flow-format packet { giga-packet | kilo-packet |
mega-packet | one-packet }
undo data-flow-format { data | packet }
Command
timer response-timeout seconds
undo timer response-timeout
Command
timer quiet minutes
undo timer quiet