3Com 8807 Configuration Manual page 815

The system assigns a channel in each output direction by default. See the table
below.
Table 764 Numbers and names of the channels for log output
Output direction
Console
Monitor
Information center loghost
Trap buffer
Logging buffer
snmp
Log file
n
The settings in the 7 directions are independent from each other. The settings will
take effect only after enabling the information center.
The information center of the switch has the following features:
Support to output log in 7 directions, i.e., Console, monitor to Telnet terminal,
■
logbuffer, loghost, trapbuffer, and SNMP log file.
The log is divided into 8 levels according to the significance and it can be
■
filtered based on the levels.
The information can be classified in terms of the source modules and the
■
information can be filtered in accordance with the modules.
The output language can be selected between Chinese and English.
■
1 Sending the configuration information to the loghost
Table 765 Send the configuration information to the loghost
Device Configuration
Enable information center
Set the information output
direction to the loghost
Switch
Set information source
Information Center Function
Channel number
0
1
2
3
4
5
6
Default value
By default, information
center is enabled
-
-
815
Default channel name
console
monitor
loghost
trapbuf
logbuf
snmpagent
logfile
Configuration
description
Other configurations are
valid only if the
information center is
enabled
The configuration about
the loghost on the switch
and that on loghost must
be the same; otherwise the
information cannot be
sent to the loghost
correctly
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information