3Com 8807 Configuration Manual page 824

824 C 71: I
HAPTER NFORMATION
n
C
ENTER
module-based filtering settings and severity threshold. When a user modifies these
settings, it will be reflected on other clients.
If you want to view the debugging information of some modules on the switch,
you must select debugging as the information type when configuring
information source, meantime using the debugging command to turn on the
debugging switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
This configuration will affect the timestamp of the displayed information.
Perform the following configuration in system view:
Table 782 Configure the output format of time-stamp
Operation
Configure the output format of the
time-stamp
Output time-stamp is disabled
4 Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must
first enable the terminal display function, and then the corresponding terminal
display function of log information on the switch.
For example, if you have specified the log information as the information sent to
the Telnet terminal or dumb terminal, now you need to use the terminal monitor
command to enable the terminal display function and the terminal logging
command to enable the terminal display function of log information on the
switch, then you can view the information at the Telnet terminal or dumb
terminal.
Perform the following configuration in user view:
Table 783 Enable terminal display function
Operation
Enable terminal display function of log,
debugging and trap information
Disable terminal display function of the above
information
Enable terminal display function of debugging
information
Disable terminal display function of
debugging information
Enable terminal display function of log
information
Disable terminal display function of log
information
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
Command
terminal monitor
undo terminal monitor
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging