3Com 8807 Configuration Manual page 190

190 C 22: Q S C
HAPTER O ONFIGURATION
Configuring Traffic
Policing
Table 159 Configure mapping tables
Operation
Configure the CoS -> Local-precedence
mapping table
Restore the default values of CoS ->
Local-precedence mapping table
By default, the switch obtains local precedence and drop precedence according to
the default mapping values.
Configuring default local precedence
Perform the following configurations in Ethernet port view.
Table 160 Configure default local precedence for port
Operation
Configure default local precedence for a port
Restore the default local precedence for a port undo priority
Perform the following configuration in port group view.
Table 161 Configure priority for the port group
Operation
Configure local priority for the port group
Restore the local priority of the port group to
the default value
Traffic policing refers to rate limit based on traffic. If the traffic threshold is
exceeded, corresponding measures will be taken, for example, dropping the
excessive packets or re-defining their priority levels.
In the traffic supervision action, the switch uses the service parameters allocated
according to the DSCP + Conform-Level -> Service parameter mapping table and
the EXP + Conform-Level -> Service parameter mapping table and the 802.1p
priority values allocated according to the Local-precedence+Conform-Level ->
802.1p priority mapping table. So you should configure these three mapping
tables or use their default values.
Configuring mapping tables
Perform the following configurations in the specified views.
Table 162 Configure mapping table
Operation
Enter conform level view (System view)
Configure the DSCP + Conform-Level ->
Service parameters mapping table (conform
level view)
Command
qos cos-local-precedence-map
cos0-map-local-prec cos1-map-local-prec
cos2-map-local-prec cos3-map-local-prec
cos4-map-local-prec cos5-map-local-prec
cos6-map-local-prec cos7-map-local-prec
undo qos cos-local-precedence-map
Command
priority priority-level
Command
priority { priority-level | trust }
undo priority
Command
qos conform-level conform-level-value
dscp dscp-list : dscp-value exp-value cos-value
local-precedence-value drop-precedence