3Com 8807 Configuration Manual page 578

578 C 49: BGP/MPLS VPN C
HAPTER
n
ONFIGURATION
# Configure CE1
[CE1] vlan 410
[CE1-vlan410] interface vlan 410
[CE1-Vlan-interface410] ip address 168.1.1.2 255.255.0.0
[CE1-Vlan-interface410] quit
# Create a VPN instance on PE1 and bind it to the interface connected to CE1
[PE1] ip vpn-instance vpna
[PE1-vpn-vpna] route-distinguisher 100:2
[PE1-vpn-vpna] vpn-target 100:1 both
[PE1-vpn-vpna] quit
[PE1]vlan 410
[PE1] interface vlan 410
[PE1-Vlan-interface410] ip binding vpn-instance vpna
[PE1-Vlan-interface410] ip address 168.1.1.1 255.255.0.0
[PE1-Vlan-interface410] quit
# Configure CE2
[CE2] vlan 510
[CE2-vlan510] interface vlan 510
[CE2-Vlan-interface510] ip address 168.2.2.2 255.255.0.0
[CE2-Vlan-interface510] quit
# Create a VPN instance on PE2 and bind it to the interface connected to CE2
[PE2] ip vpn-instance vpna
[PE2-vpn-instance] route-distinguisher 200:2
[PE2-vpn-instance] vpn-target 100:1 both
[PE2-vpn-instance] quit
[PE2] vlan 510
[PE2] interface vlan 510
[PE2-Vlan-interface510] ip binding vpn-instance vpna
[PE2-Vlan-interface510] ip address 168.2.2.1 255.255.0.0
[PE2-Vlan-interface510] quit
4 Configure MP-BGP, set up IBGP peer relation between PEs, and set up EBGP peer
relation between PEs and their CEs.
Enable the exchanging of label-carried IPv4 route between the following
■
routers: PE1 and ASBR-PE1, PE2 and ASBR-PE2, ASBR-PE1 and ASBR-PE2.
Make each ASBR-PE change the next hop to its own when it advertises routes
■
to the PE in the same AS.
Configure routing policy on each ASBR-PE as follows: make the ASBR-PE assign
■
MPLS label when it advertises a route received from the PE in this AS to the
ASBR-PE in the peer AS, and let the ASBR-PE assign a new MPLS label when it
advertises a label-carried IPv4 route to the PE in this AS.
# Configure CE1
[CE1] bgp 65001
[CE1-bgp] group 20 external