Displaying and
Debugging AAA and
RADIUS Protocol
Table 240 Set a real-time accounting interval
Operation
Set a real-time accounting interval
Restore the default real-time accounting
interval
The interval is in minutes and must be a multiple of 3.
The setting of real-time accounting interval somewhat depends on the
performance of the NAS and the TACACS server: a shorter interval requires higher
device performance. You are therefore recommended to adopt a longer interval
when there are a large number of users (more than 1000, inclusive). The following
table lists the numbers of users and the recommended intervals.
Table 241 Numbers of users and the recommended intervals
Number of users
1 to 99
100 to 499
500 to 999
ƒ
¶1000
The real-time accounting interval defaults to 12 minutes.
After the above configuration, execute display command in any view to display
the running of the AAA and RADIUS/HWTACACS configuration, and to verify the
effect of the configuration. Execute reset command in user view to reset AAA and
RADIUS/HWTACACS statistics, etc. Execute debugging command in user view to
debug AAA and RADIUS/HWTACACS.
Table 242 Display and debug AAA and RADIUS/HWTACACS protocol
Operation
Display the configuration
information of the specified or all
the ISP domains
Display related information of
user's connection
Display related information of the
local user
Display the statistics of local
RADIUS server group
Display the configuration
information of all the RADIUS
server groups or a specified one
Displaying and Debugging AAA and RADIUS Protocol
Command
timer realtime-accounting minute
undo timer realtime-accounting
Real-time accounting interval (in minutes)
3
6
12
ƒ
¶15
Command
display domain [ isp-name ]
display connection { access-type { dot1x | gcm } |
domain isp-name | hwtacacs-scheme
hwtacacs-scheme-name | interface interface-type
interface-number | ip ip-address | mac mac-address |
radius-scheme radius-scheme-name | vlan vlanid |
ucibindex ucib-index | user-name user-name }
display local-user [ domain isp-name | idle-cut { disable
| enable } | service-type { ftp | lan-access | ppp | ssh |
telnet | terminal } | state { active | block } | user-name
user-name | vlan vlanid ]
display local-server { statistics | nas-ip }
display radius [ radius-server-name ]
261