3Com 8807 Configuration Manual page 96

96 C 13: E
HAPTER THERNET
Copying Port
Configurations to Other
Ports
P C
ORT ONFIGURATION
already carries a VLAN Tag, the packet will get two Tags; if the part receives an
untagged packet, the packet will be given a default VLAN Tag of the port.
Perform the following configuration in Ethernet port view.
Table 81 Setting the port VLAN VPN feature
Operation
Enable the port VLAN VPN feature
Disable the port VLAN VPN feature
Note that if any of GVRP, STP, and 802.1x has been enabled on a port, the VLAN
VPN feature cannot be enabled on the port.
By default, the port VLAN VPN feature is disabled.
To keep the configurations of other ports consistent with a specified port, you can
use copy configuration command to copy the configurations of that specified
port to other ports. Such configurations may involve: STP setting, QoS setting,
LACP setting, and port setting. The detailed table is as follows:
Table 82 Configurations that can be copied
Attribute
STP setting
QoS setting
Port setting
Command
vlan-vpn enable
undo vlan-vpn
Detailed Setting
Enable/disable STP
Port priority
Path cost
Link attributes(point-to-point or not)
Port mCheck
Max transmission speed
Enable/disable root protection
Enable/disable loop protection
Edge or non-edge port
Reset ARP or not
Define/apply flow template
Traffic reshaping
Traffic redirection
Packet filtering
Priority re-assignment
Traffic statistics
Traffic mirroring
Rate limiting
Permitted VLAN ID
Default VLAN ID
Add ports to VLAN
Default 802.1p priority
Port speed, duplex mode
Port link type