3Com 8807 Configuration Manual page 52

52 C 6: C
HAPTER ONFIGURATION
Modifying and Saving
Current-Configuration
Erasing Configuration
Files from Flash Memory
Configuring the Name of
the Configuration File
Used for the Next
Startup.
F M
ILE ANAGEMENT
Table 29 Display the configurations of the switch
Operation
Display the saved-configuration information
of the switch
Display the current-configuration information
of the Ethernet switch
Display the running configuration of the
current view
n
The configuration files are displayed in their corresponding saving formats.
You can modify the current configuration of the switch through the CLI. Use the
the save command to save the current-configuration in the Flash Memory, and the
configurations will become the saved-configuration when the system is powered
on for the next time.
Perform the following configuration in user view.
Table 30 Save the current-configuration
Operation
Save the current-configuration
Even if the problems like reboot and power-off occur during , the configuration
file can be still saved to Flash.
The reset saved-configuration command can be used to erase configuration
files from Flash Memory. The system will use the default configuration parameters
for initialization when the switch is powered on for the next time.
Perform the following configuration in user view.
Table 31 Erase configuration files from Flash Memory
Operation
Erase configuration files from Flash Memory
You may erase the configuration files from the Flash in the following cases:
After being upgraded, the software does not match with the configuration
■
files.
The configuration files in flash are damaged. (A common case is that a wrong
■
configuration file has been downloaded.)
Perform the following configuration in user view.
Command
display saved-configuration
display current-configuration [ controller |
interface interface-type interface-number |
configuration [ configuration ] ] [ | { begin |
exclude | include } regular-expression ]
display this
Command
save [ file-name ]
Command
reset saved-configuration