3Com 8807 Configuration Manual page 742

8800 series
Hide thumbs Also See for 8807:
Table of Contents

Advertisement

742
C
64: SNMP C
HAPTER
n
Adding/Deleting a User
to/from an SNMP Group
Creating/Updating View
Information or Deleting
a View
ONFIGURATION
Perform the following configuration in system view.
Table 685 Set the source address of trap
Operation
Set the Source Address of Trap
Remove the source address of trap
Currently, this command takes effect only on the interfaces with vlan-interface
type.
You can use the following commands to add or delete a user to/from an SNMP
group.
Perform the following configuration in system view.
Table 686 Add/Delete a user to/from an SNMP group
Operation
Add a user to an SNMP
group.
Delete a user from an
SNMP group.
You must first configure the SNMP engine ID before configuring the remote user
for an agent, because the engine ID is required during the authentication. If you
forget to configure the engine ID before adding a user, the operation of adding
this user will fail.
For SNMP V1 and V2c, this operation is adding a new community name, while for
SNMP V3, this operation is adding a user for an SNMP group.
You can specify the view to control the access to the MIB by SNMP manager. You
can use either the predefined views or the self-defined views. You can use the
following commands to create, update the information of views or delete a view.
Perform the following configuration in system view.
Table 687 Create/Update view information or delete a view
Operation
Create/Update view information
Delete a view
Command
snmp-agent trap source interface-type
interface-number
undo snmp-agent trap source
Command
snmp-agent usm-user { v1 | v2c } username groupname [ acl
acl-list ]
snmp-agent usm-user v3 username groupname [
authentication-mode { md5 | sha } authpassstring [
privacy-mode { des56 privpassstring } ] ] [ acl acl-list ]
undo snmp-agent usm-user { v1 | v2c } username groupname
undo snmp-agent usm-user v3 username groupname { local |
engineid engine-id }
Command
snmp-agent mib-view { included | excluded } view-name
oid-tree
undo snmp-agent mib-view view-name

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

88108814

Table of Contents