Basic Portal Configuration - 3Com 8807 Configuration Manual

270 C 27: P
HAPTER ORTAL
Basic Portal
Configuration
Configuration
Prerequisites
Basic Portal
Configuration Procedure
C
ONFIGURATION
A valid IP address has been configured for this portal-enabled VLAN interface.
■
802.1x is not enabled on the switch.
■
The Portal server has been installed and configured. Refer to CAMS Portal
■
Service Components User's Guide for details about installation and
configuration.
n
Refer to the "Network Protocol" section in 3Com Switch 8800 Family Series
■
Routing Switches-Operation Manual for DHCP configuration.
Refer to Chapter 2 AAA&RADIUS Protocol Configuration for AAA&RADIUS
■
configuration.
The following table describes the basic Portal configuration procedure.
Table 244 Basic Portal configuration procedure
Operation
Enter system view
Configure the Portal server
Configure the running
method of Portal
Configure the authentication
network segment
Configure the interval of
handshakes with user PCs and
the maximum retry times
Enter VLAN interface view
Command
system-view
portal server server-name {
ip ip-address | key key-string |
port port | url url-string } *
portal method { direct |
layer3 | redhcp }
portal auth-network
network-address net-mask
vlan vlan-id
portal arp-handshake {
interval interval | retry-times
retry-times }*
interface vlan-interface
vlan-id
Description
-
Required
No Portal server is configured
by default. When a Portal
server is configured, the
key-string is 3Com, the port is
50100 and the url-string is the
string format of ip-address by
default.
Optional
The direct authentication
method is adopted in Portal
authentication by default.
This command must be
configured if the Layer 3
authentication method is
adopted in Portal
authentication. This
procedure is omitted in other
methods.
Optional
This task is effective only for
the Direct authentication
method and the ReDHCP
authentication method. By
default, the interval of ARP
handshakes is 60 seconds,
and the maximum retry times
is five times.
The following displayed
information in VLAN interface
view is corresponding to the
input vlan-id