3Com 8807 Configuration Manual page 725

Table 669 PoE configuration tasks on the Switch 8800 Family series
No Operation
1 Enter system view
Configure the maximum
2
power of switch
3 Enable PoE on a module
Enable the module to detect
4 the compatibility of the PD
connected to it
Configure the PoE power
5 management for a module
on the switch
6 Enter Ethernet port view
7 Enable PoE on the port
Set the maximum PoE
8
power supplied by the port
Set the PoE mode on the
9
port
Set the PoE priority on the
10
port
To cancel the configurations, use the corresponding undo commands. For details
about the parameters, refer to the Command Manual.
n
Before setting the maximum power supplied by a card, make sure the
■
remaining power of the switch is no less than the full power of the card, and
the power you can set for a card ranges from 37 W to 806 W.
Command
system-view
poe power max-value
max-value
poe enable slot slot-num
poe legacy enable slot
slot-num
poe power-management {
auto | manual } slot
slot-num
interface interface-type
interface-number
poe enable
poe max-power
max-power
poe mode { signal | spare|
auto }
poe priority { critical |
high | low }
PoE Configuration 725
Description
-
Optional
By default, the maximum
power of the switch is 4,500
W.
Required
By default, PoE is disabled
on a module.
Optional
By default, the module does
not detect the compatibility
of the PD connected to it.
Optional
By default, you manually
manage PoE power supply
for the module on the
switch.
As a result of this
command, a port view
prompt is displayed, which
varies with the port type you
selected.
Optional
By default, PoE is disabled
on a port.
Optional
You can set the maximum
PoE power supplied by a
port depending on the
power of the actual PD. By
default, the max-power is
16,800 mW.
Switch 8800 Family series
supports only signal line PoE
mode. By default, the PoE
mode on a port is signal.
Optional
You can set the PoE priority
on a port depending on the
practical situation. By
default, the PoE priority on a
port is low.