828
C
71: I
HAPTER
NFORMATION
n
Sending the
Configuration
Information to SNMP
Network Management
n
C
ENTER
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the switch,
you must select debugging as the information type when configuring
information source, meantime using the debugging command to turn on the
debugging switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
This configuration will affect the timestamp of the displayed information.
Perform the following configuration in system view:
Table 791 Configure the output format of time-stamp
Operation
Configure the output format of the
time-stamp
Output time-stamp is disabled
To send configuration information to SNMP NM, follow the steps below:
1 Enabling information center
Perform the following configuration in system view.
Table 792 Enable/disable information center
Operation
Enable information center
Disable information center
Information center is enabled by default. After information center is enabled,
system performances are affected when the system processes much information
because of information classification and outputting.
2 Configuring to output information to SNMP NM
Perform the following configuration in system view.
Table 793 Configure to output information to SNMP NM
Operation
Output information to SNMP NM
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
Command
info-center enable
undo info-center enable
Command
info-center snmp channel { channel-number
| channel-name }
Need help?
Do you have a question about the 8807 and is the answer not in the manual?