Displaying The Status And Information Of The System; System Debugging - 3Com 8807 Configuration Manual

836 C 72: S
HAPTER YSTEM
Displaying the Status
and Information of
the System

System Debugging

Enabling/Disabling the
Terminal Debugging
M D
AINTENANCE AND EBUGGING
Table 800 Set the summer time
Operation
Set the name and range of the summer time
Remove the setting of the summer time
By default, the summer time is not set.
The switch provides the display command for displaying the system status and
statistics information.
For the display commands related to each protocols and different ports, refer to
the relevant chapters. The following display commands are used for displaying
the system status and the statistics information.
Perform the following configuration in any view.
Table 801 The display commands of the system
Operation
Display the system clock
Display the system version
Display the status of the debugging
Display the information about the optical
module connected with a in-position optical
port on current frame
The switch provides various ways for debugging most of the supported protocols
and functions, which can help you diagnose and locate the errors.
The following ON/OFF switches can control the outputs of the debugging
information:
Protocol debugging ON/OFF switch controls the debugging output of a
■
protocol.
Terminal debugging ON/OFF switch controls the debugging output on a
■
specified user screen.
The figure below illustrates the relationship between two ON/OFF switches.
Command
clock summer-time zone-name { one-off |
repeating } start-time start-date end-time
end-date offset-time
undo clock summer-time
Command
display clock
display version
display debugging [ interface { interface-
type interface-number ] [ module-name ]
display fiber-module
or
display fiber-module [ interface-type
interface-number ]