n
Information center is enabled by default. After information center is enabled,
system performances are affected when the system processes much information
because of information classification and outputting.
2 Configuring to output information to Telnet terminal or dumb terminal
Perform the following configuration in system view.
Table 780 Configure to output information to Telnet terminal or dumb terminal
Operation
Output information to Telnet terminal or
dumb terminal
Cancel the configuration of outputting
information to Telnet terminal or dumb
terminal
3 Configuring information source on the switch
By this configuration, you can define the information that sent to Telnet terminal
or dumb terminal is generated by which modules, information type, information
level, and so on.
Perform the following configuration in system view:
Table 781 Define information source
Operation
Define information source
Cancel the configuration of information
source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number
except default; level refers to the severity levels; severity specifies the severity level
of information. The information with the level below it will not be output.
channel-number specifies the channel number and channel-name specifies the
channel name.
When defining the information sent to Telnet terminal or dumb terminal,
channel-number or channel-name must be set to the channel that corresponds to
monitor direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
n
When there are more than one Telnet users or monitor users at the same time,
some configuration parameters should be shared among the users, such as
Information Center Function
Command
info-center monitor channel {
channel-number | channel-name }
undo info-center monitor channel
Command
info-center source { modu-name | default }
channel { channel-number | channel-name } [
debug { level severity | state state }* | log {
level severity | state state }* | trap { level
severity | state state }* ]*
undo info-center source { modu-name |
default | all } channel { channel-number |
channel-name }
823
Need help?
Do you have a question about the 8807 and is the answer not in the manual?