Configuring CDP Compatibility
Configuring LLDP Trapping
LLDP-related configurations made in Ethernet interface view takes effect only on the current port, and
those made in port group view takes effect on all ports in the current port group.
Performing Basic LLDP Configuration
To make LLDP take effect on certain ports, you need to enable LLDP both globally and on these ports.
Follow these steps to enable LLDP:
Enter system view
Enable LLDP globally
view or port
Setting LLDP Operating Mode
LLDP can operate in one of the following modes.
TxRx mode. A port in this mode sends and receives LLDP frames.
Tx mode. A port in this mode only sends LLDP frames.
Rx mode. A port in this mode only receives LLDP frames.
Disable mode. A port in this mode does not send or receive LLDP frames.
Follow these steps to set LLDP operating mode:
Setting Other LLDP Parameters
Setting an Encapsulation Format for LLDPDUs
Use the command...
By default, LLDP is enabled
Use either command.
By default, LLDP is enabled on