Displaying And Debugging Aaa And Radius Protocol - 3Com 5500-SI Configuration Manual

430 C 21: 802.1
HAPTER
Displaying and
Debugging AAA and
RADIUS Protocol
C
X ONFIGURATION
Configure the RADIUS Server Response Timer
If the NAS receives no response from the RADIUS server after sending a RADIUS
request (authentication/authorization or accounting request) for a period of time, the
NAS resends the request, thus ensuring the user can obtain the RADIUS service. You
can specify this period by setting the RADIUS server response timeout timer, taking
into consideration the network condition and the desired system performance.
Perform the following configurations in RADIUS Scheme View.
Table 469 Configure the RADIUS Server Response Timer
Operation
Configure the RADIUS server response timer
Restore the default value of the interval
By default, the response timeout timer for the RADIUS server is set to three seconds.
After the above configuration, execute the
the running of the AAA and RADIUS configuration, and to verify the effect of the
configuration. Execute the
statistics. Execute the
Table 470 Displaying and Debugging AAA and RADIUS Protocol
Operation
Display the configuration information of
the specified or all the ISP domains.
Display related information of user's
connection
Display related information of the local user display local-user [ domain isp_name |
Display the statistics of local RADIUS
authentication server
Display the configuration information of all
the RADIUS schemes or a specified one
Display the statistics of RADIUS packets
Display the stopping accounting requests
saved in buffer without response (from
System View)
Delete the stopping accounting requests
saved in buffer without response (from
System View)
Command
timer response-timeout seconds
undo timer response-timeout
display
command in User View to reset AAA and RADIUS
reset
command in User View to debug AAA and RADIUS.
debugging
Command
display domain [ isp_name ]
display connection [ access-type {
dot1x | mac-authentication } | domain
domain_name | interface
interface_type interface_number | ip
ip_address | mac mac_address |
radius-scheme radius_scheme_name |
vlan vlanid | ucibindex ucib_index |
user-name user_name ]
idle-cut { disable | enable } |
service-type { telnet | ftp |
lan-access | ssh | terminal } | state
{ active | block } | user-name
user_name | vlan vlan_id ]
display local-server statistics
display radius [ radius_scheme_name ]
display radius statistics
display stop-accounting-buffer {
radius-scheme radius_scheme_name |
session-id session_id | time-range
start_time stop_time | user-name
user_name }
reset stop-accounting-buffer {
radius-scheme radius_scheme_name |
session-id session_id | time-range
start_time stop_time | user-name
user_name }
command in any view to display