Displaying And Debugging Aaa And Radius Protocol - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Table 40-37 Set a real-time accounting interval
Set a real-time accounting interval
Restore the default real-time accounting
interval
The interval is in minutes and must be a multiple of 3.
The setting of real-time accounting interval somewhat depends on the performance of
the NAS and the TACACS server: a shorter interval requires higher device performance.
You are therefore recommended to adopt a longer interval when there are a large
number of users (more than 1000, inclusive). The following table lists the numbers of
users and the recommended intervals.
Table 40-38 Numbers of users and the recommended intervals
Number of users
1 to 99
100 to 499
500 to 999
ƒ1000
The real-time accounting interval defaults to 12 minutes.

40.5 Displaying and Debugging AAA and RADIUS Protocol

After the above configuration, execute display command in any view to display the
running of the AAA and RADIUS/TACACS+ configuration, and to verify the effect of the
configuration. Execute reset command in user view to reset AAA and
RADIUS/TACACS+ statistics, etc. Execute debugging command in user view to
debug AAA and RADIUS/TACACS+.
Table 40-39 Display and debug AAA and RADIUS/TACACS+ protocol
Display the configuration information of
the specified or all the ISP domains
Chapter 40 AAA and RADIUS/TACACS+ Protocol Con
Operation
Real-time accounting interval (in minutes)
3
6
12
ƒ15
Operation
40-29
Command
timer realtime-accounting minutes
undo timer realtime-accounting
Command
display domain [ isp-name ]
figuration