Adjusting The Mechanical Stitch Adjustment; Presetting The Stitch Regulator Gear Mechanically - Dürkopp Adler D869 e-con Service Instructions Manual

6
6.1
Proper setting
The stitch regulator gear is set to 0.
 The plates (1) are parallel to each other when the control cam is
The stitch length is controlled by a stepper motor. The exact zero stitch (stitch
length 0 = no feed) is determined by the Calibration zero stitch ( p. 169).
Cover
44

Adjusting the mechanical stitch adjustment

WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you set the
mechanical stitch adjustment.

Presetting the stitch regulator gear mechanically

disconnected.
There must be no lateral play at the stitch regulator gear.
• Remove the toothed belt cover ( p. 23)
• Motor cover ( p. 22)
• Remove the front cover ( p. 20)
Adjusting the mechanical stitch adjustment
Service Instructions D869 e-con - 00.0 - 09/2023