Setting Of Cam Torsion Spring Pressure On Step Length Setting Wheel Screw - Dürkopp Adler 52Xi Service Instructions Manual

10.7 Setting of cam torsion spring pressure on step length
Pic. 48: Setting of cam torsion spring
①
②
③
④
⑤
⑥
(1) - Setting wheel
(2) - Setting wheel screw
(3) - Cam
(4) - Torsion spring
1. Loosen two setting screws (7) of the setting ring (8).
2. Set the maximum value of 7 mm on the setting wheel (1).
3. Insert the hexagonal key 3 mm (6) into the other hole (in the turning
4. Turn the setting ring (8) in the direction of the spring winding and lean
5. Tighten two setting screws (7).
60
setting wheel screw
direction) of the setting ring (8).
it against the rod (7).
⑧
⑦
⑥
⑤
(5) - Rod
(6) - Hexagonal key 3 mm
(7) - Setting screws
(8) - Setting ring
Service Instructions 52Xi, 52Xi-75 - 03.0 - 09/2023
Puller