Monitor/Solo; About Monitoring - Roland M-200i V-mixer Owner's Manual

Monitor/Solo

About monitoring

fig.MonitorFlow.eps
SOLO
LR
MONITOR
MONITOR
SELECT
AUX 1 OUT
AUX 8 OUT
MAIN OUT L
MAIN OUT R
MONO OUT
MTX 1 OUT
MTX 4 OUT
REC OUT LR
LR
SOLO
Monitoring is a function by which the
from the output jacks or headphone jack. This is used mainly by a mixing engineer to monitor the signals.
The monitor output is split to the MONITOR OUT L/R and PHONES OUT, and the level of these two can be adjusted independently. You can
use the output patchbay to patch MONITOR OUT L/R to any desired output jacks.
Solo is a function by which the channel you select using a [SOLO] button is sent from the MONITOR OUT L/R or PHONES OUT jacks. This is
used to monitor a channel temporarily.
MONITOR screen
1.
In the top panel's DISPLAY section, press [SETUP].
2.
At the SETUP screen, select "MONITOR" and press
[ENTER].
The MONITOR screen is displayed.
Meter display
1
These indicate the levels of AUX, MTX, MAIN, and MONITOR.
MONITOR LEVEL
2
This adjusts the output level of the monitor in a range of -Inf
dB to +10.0 dB.
DELAY button
3
This turns delay on/off.
Delay time
4
This adjusts the amount of delay in a range of 0.0 ms to 400
ms (when milliseconds are used).
92
SOLO MONITOR
LOGIC
DELAY
DELAY
SOLO
LEVEL
AUX, MTX, MAIN, or USB memory recorder signal that you select as the monitor source can be sent
MONITOR
LEVEL
DIRECT OUT 1-32
TALKBACK / OSC
REAC INPUT 1-40
USB PLAYER L, R
DOCK INPUT L, R
MONITOR FUNCTION screen
1.
Access the MONITOR screen.
2.
Press [FUNC] to access the MONITOR FUNCTION screen.
The operations available at the MONITOR FUNCTION screen are
as follows:
MONITOR This selects the monitor source.
SOURCE
SOLO MODE This lets you select the solo mode from among the
following:
ADD ON : Channels for which [SOLO] is on are mixed
for monitoring.
LAST : Only the channel for which [SOLO] was turned
on most recently is monitored.
SOLO LEVEL This adjusts the solo level in a range of -Inf dB to
+10.0 dB.
OUTPUT
P ATCHBAY
MONITOR OUT L
MONITOR OUT R
INPUT 1–24
PHONES
LEVEL
D/A
PHONES OUT
The solo output level is adjusted not only by
SOLO LEVEL, but also by "MONITOR LEVEL"
or the "PHONES jack LEVEL knob."