Table of Contents
Advertisement
IMPORTANT
NOTES
Power SuppiyO
@The
appropriate
power
supply
for
this
unit
is
shown on its name plate. Please make sure that the
line voltage in vour country meets the requirement.
@o
not use the same
socket
used for any noise
generating
device
(such
as a motor
or variable
lighting system.)
@Make
sure
that
the
unit
is turned
off before
connecting the power plug to the AC socket.
@Be sure to connect the power cord to the AC socket
on this unit before connecting the power plug to the
wall socket.
@When disconnecting the power plug from the socket.
do not pull the cord but hold the plug to avoid
damaging the cord.
@ Avoid damaging the power cord.
@If the unit is not to be used for a long period of
time, unplug the cord from the socket.
@lt is normal
for this unit to become
hot while
being operated.
@Check with vour local Roland dealer. if you wish to
use this unit in another country.
@ Disconnect the AC cord immediately in the event of
an electrical storm.
@Pin
connection
of
the
XLR
type
connector
is
standardized to the Ist pin-Ground. the 2nd pin-Cold
and the 8rd pin-Hot of this unit.
Location&
@Be sure to turn on the mixer before turning on the
amplifier.
Likewise
turn
the amphfire off first.
then the mixer.
Before
taking procedures.
set the
faders of the mixer to the "0" positions.
@Avoid
using
this
device
in
excessive
humidity
conditions.
ar where
it may
be affected
by direct sunhgnt or dust and avoid places subject
to high vibration.
@Operating
the unit
near
a neon
hight. fluorescent
lamp.
TV
or
CRT
Display.
may
cause
noise
interference.
If sc. change the angle or the positon
get
of the
unit.
@lfa
device with 6 large-sized transformer. such as
@
power
amplifier,
is mounted
just
ahove
this
device. hum mav be produced.
@o
not place or drop anything heavy on the main
unit
or
1ts power
cord,
OCleaning CareO
@For cleaning the unit, use a dry and soft cloth.
@If
the
casing
is stained,
use
a cloth
slightly
dampened with water
@7To remove stubborn stains. clean the casing with @
cloth moistened with a nutral detergent, then wipe
it dry with a soft cloth.
@Do
not
use
solvents
such
as paint
thinner
when
cleaning.
OOthersO
:
@For
approximately
3 seconds
after
the unit
is
turned on.
the muting
circuit functions.
therefore
no sound is heard.
@When
switching on/off during performance. a click
noise
will
be produced.
There
no
need
ty be
concerned.
€ vou have
@e
sure
to read page
caretutis
the Phantom Switch's Cover off.
@be sure te set the Phantom Switches to the OFF
positions excep? when using a condenser microphone
which requires
external power supply
Advertisement
Table of Contents
