Input And Output Settings; Input And Recording Settings (Input/Rec); Using An External Effect; (Send/Return Jacks) - Roland Groovebox MC-707 Reference Manual

Input and Output Settings

Input and Recording Settings
Here's how to make external input settings, and settings for looper
recording.
1 .
Hold down the [SHIFT] button
The INPUT/OUTPUT/REC SETTING screen appears.
Parameter Value
MIC SENSE 0–7
EXT IN MONO, STEREO
EXT,
PC,
REC SRC
TRK1–8,
MIXOUT
REC MEAS 1–8
(INPUT/REC)
and press the [INPUT] button .
Explanation
Specifies the MIC IN gain.
* This is valid when the rear panel input switch
is set to MIC IN.
Switches the EXT IN input between mono
or stereo.
Specifies the recording source for the
Looper.
EXT: Record from the EXT IN jacks.
PC:
Record from the PC IN port of USB
audio.
TRK 1–8:
Record from a track.
MIXOUT:
Record the audio output of the
entire MC-707.
* If the USB Mix Select setting is POST T-FX, the
audio input from the USB MIX OUT port is not
recorded.
Specifies the clip length (number of
measures) that will be recorded.

Using an External Effect

This allows you to connect an external effects device to the SEND/
RETURN jacks and use it as part of the MC-707's effects.
1 .
Connect your effect unit to the SEND/RETURN jacks .
External Effect
2 .
Hold down the [SHIFT] button
The input/output settings are displayed.
3 .
Use the cursor buttons to select the SEND/RETURN tabs,
and make settings .
Parameter Value
SEND tab
OFF,
PC,
TRACK1–8,
POS DELAY,
REVERB,
SCATTER,
MIXOUT
LEVEL 0–255
MONO,
SEND
STEREO
RETURN tab
OFF,
PC,
TRACK1–8,
POS DELAY,
REVERB,
SCATTER,
MIXOUT
LEVEL 0–255
MONO,
RETURN
STEREO

Individually Outputting Each Track

(ASSIGNABE OUT)

A specified track can be output from the ASSIGNABLE OUT jacks.
The ASSIGNABLE OUT setting is made in the track settings.
1 .
Hold down the [SHIFT] button
& For details, refer to
"Making Track Settings"

(SEND/RETURN Jacks)

and press the [INPUT] button .
Explanation
Specifies the position at which SEND/
RETURN is used.
Specifies the SEND output level.
Switches the SEND output between mono
and stereo.
Specifies the position at which SEND/
RETURN is used.
This is the same setting as in the SEND tab.
Specifies the RETURN input level.
Switches the RETURN input between mono
and stereo.
and press the [SEL] button .
(p. 20).
53