Selector Lever Cable - Exploded View Of Components - Audi A8 2003 Workshop Manual

Note
Nuts -3- for lateral adjustment and/or bolts -4- for vertical ad‐
♦
justment have to be loosened in order to align selector mech‐
anism with centre console switch panel.
-Item 1- and -item 2- can be disregarded.
♦
– Install front ashtray in centre console switch panel ⇒ General
body repairs, interior; Rep. Gr. 68 .
– Check selector mechanism
– Deactivate jacking mode ⇒ Running gear, front-wheel drive
and four-wheel drive; Rep. Gr. 43 ; Adaptive air suspension .
Tightening torques
Component
Cover for shift unit to body
Shift unit to cover for shift unit
Front cross member to body
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
4.9

Selector lever cable - exploded view of components

permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
1 - Selector shaft lever
❑ With damper
2 - Locking plate
❑ For selector lever cable
3 - Selector lever cable
❑ Do not bend or kink
❑ Before installing, lightly
lubricate ball socket with
polycarbamide grease -
G 052 142 A2- .
❑ Removing and installing
⇒ page 28
❑ Adjusting ⇒ page 33
❑ Selector lever cable
must be renewed if rub‐
ber sleeve is damaged
❑ When installing, make
sure that rubber sleeve
on gearbox end is not
twisted
4 - Locking plate
❑ For selector lever cable
5 - Rubber sleeve for selector
lever cable
❑ Check if rubber sleeve
for selector lever cable
is correctly hooked into
cover of shift unit and
make sure it seals it off
properly.
⇒ page 15 .
with respect to the correctness of information in this document. Copyright by AUDI AG.
multitronic 01J, front-wheel drive - Edition 11.2007
Nm
8
3.5
23
Audi A8 2003 ➤
4. Servicing selector mechanism
27