Removing And Installing Button For Interior Monitor; Removing And Installing Tailgate/Boot Lid Contact Switch - Up To Model Year 2000 - Audi A3 1997 Service

Removing
- Remove front door trim.
=> General Body Repairs, Interior; Repair Group 70
- Lay bare wire to central locking switch.
- -> Release retainer tabs -arrows- and press central locking switch -1- out of driver's door trim.
Installing
Install in reverse order.

1.19 - Removing and installing button for interior monitor

Removing
- Remove B-pillar trim on driver's side.
=> General Body Repairs, Interior; Repair Group 70
- Unplug connector.
- -> Use small screwdriver to press in clip of button on side.
- Press button for interior monitor -arrow- to front out of B-pillar trim.
Installing
Install in reverse order.

1.20 - Removing and installing tailgate/boot lid contact switch - up to Model Year 2000

Electrical system - Edition 10.2003
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.18 - Removing and installing front central locking switch
Audi A3 1997 ➤
171