FIGURE 3-3
3.2.1
Reading Boot Messages
Use the boot software messages to verify that all options are installed and
recognized by the system. After firmware completes the system self-test, a message
similar to the following will appear on your screen. The message lists hardware
detected in the system.
Note – This screen display is an example only. The actual message displayed on the
screen will depend on the software running on your system.
5-slot Sun Enterprise 3500, Keyboard Present
OpenBoot -.- FCS, --- MB memory installed, Serial #---.
Ethernet address -:-:--:-:--:--, Host ID: ------.
If firmware indicates a hardware problem at this time, refer to the
Sun Enterprise 3500 System Reference Manual, Part 3, "Troubleshooting," for further
instructions.
CPU Reset Switch on Clock+ Board
Chapter 3
Powering the System On and Off
System
reset switch
CPU
reset switch
3-5