Table of Contents
Advertisement
Sun Blade 1000 and Sun Blade 2000
UltraSPARC III Cu CPU Module
Installation Guide
This document describes how to remove or install an UltraSPARC ® III Cu CPU
module for the Sun Blade™ 1000 or Sun Blade 2000 workstation. The following
topics are discussed:
"Installation Kit Contents" on page 1
"Rules for Installing Cu CPU Modules" on page 2
"Identifying Cu CPU Modules" on page 3
"OpenBoot PROM and Software Requirements for UltraSPARC III Cu CPU
Modules" on page 5
"Installing the UltraSPARC III Cu CPU Module" on page 5
"Where to Find More Information" on page 26
Note – To install an UltraSPARC III 600, 750, or 900 MHz non Cu CPU module in a
Sun Blade 1000 workstation, see the Sun Blade 1000 UltraSPARC III Module
Installation Instructions, 816-0416-11.
Installation Kit Contents
Your UltraSPARC III Cu CPU module installation kit contains:
UltraSPARC III Cu CPU module
CPU torque tool
Disposable antistatic wrist strap
1
Advertisement
Table of Contents
