Media Tray Data And Dc Power Cable Assemblies - Sun Microsystems Enterprise 3500 System Reference Manual

E.4.3

Media Tray Data and DC Power Cable Assemblies

E.4.3.1 Removing the Data and Power Cables
1. Remove the panels covering the data and power cables.
Complete the steps in Section E.4 "Removing the Front and Side Panels."
2. Reach through the space previously occupied by the front decorative (perforated)
panel and disconnect the SCSI cables from the centerplane.
3. Cut the cable ties that secure the cables to the chassis.
4. Remove the cables.
E.4.3.2 Replacing the Data and Power Cables
1. Connect the cables to the back of the media tray.
Note – The SCSI data and power cables are keyed so that the cables fit into the
connectors in only one direction and cannot be reversed.
2. Place the cables through the chassis opening vacated by the media tray. Drop the
cables through the bottom opening.
The cables should be visible through the opening normally covered by the front
decorative (perforated) panel (
3. Reach through the space normally covered by the front decorative panel and
connect the cables to the centerplane (
E-10 Sun Enterprise 3500 System Reference Manual • August 2001
).
FIGURE E-6
).
FIGURE E-7