Keithley SourceMeter 2600 Series Reference Manual page 75

Series 2600 System SourceMeters Reference Manual TSP Programming Fundamentals 2-23
Script launch configuration
A script is to be loaded into the Series 2600 where it will be executed (run). The
launch configuration options include the following:
•
•
•
•
When a script project is created, the launch is configured initially as follows:
•
•
•
NOTE
The flowchart in
configuration for a script. The labels (A through G) are used to identify reference
links which follow the illustration.
Figure 2-12
Changing a launch configuration
Reference links for labels A through G shown in
A "Starting Test Script Builder"
B "Opening communications"
C "Displaying the launch configuration
D "Selecting a configuration"
E "Selecting script files and launch
F "Selecting the type of launch"
G "Storing the script"
Select which script files will be included in the launch.
Set the launch order for the selected script files.
Set the script launch to load-only, or to load-and-execute (run).
Set script storage for the Series 2600: volatile or non-volatile. A script
stored in volatile memory will be lost when the SourceMeter power is turned
off. A script stored in non-volatile memory will not be lost after power is
turned off.
Only the first script file ("main") is selected to be included in the launch.
The launch type is set to load-and-execute (run).
The script project is set to be stored in the volatile memory of the Series
2600. The script will be lost when the Series 2600 power is turned off.
If the initial launch configuration meets your requirements, the
script is ready to be launched and is explained in
script" later in Section 2.
Figure 2-12
Figure
window"
order"
Return to
shows the basic process to change the launch
2-12:
Section 2 topics
"Launching a
2600S-901-01 Rev. A / May 2006