Keithley SourceMeter 2600 Series Reference Manual page 156

4-20 Basic Operation
Figure 4-4
4-wire resistance sensing
Sense selection
Front panel sense selection
To select sensing mode:
1.
2.
3.
Remote sense selection
Use the smuX.sense command to control sense selection by remote. For
example, send this command to enable 4-wire sensing:
smua.sense = smua.SENSE_REMOTE
See
2600S-901-01 Rev. A / May 2006
Press the CONFIG key then press MEAS. Choose V-MEAS, and then
press ENTER or the Rotary Knob.
Select SENSE-MODE, then press ENTER.
Choose 2-WIRE or 4-WIRE, as desired, and then press ENTER or the
Rotary Knob.
Table 4-7 and Section 12
Return to
Series 2600 System SourceMeters Reference Manual
for details.
Section 4 topics