Keithley SourceMeter 2600 Series Reference Manual page 65

Series 2600 System SourceMeters Reference Manual TSP Programming Fundamentals 2-13
The RS-232 settings can be changed from the communications menu. To access
the menu, press the MENU key, select COMMUNICATIONS, and then select
RS-232.
The RS-232 settings are stored in non-volatile memory. The settings will not
change when power is cycled or a reset command (
Using Test Script Builder
Test Script Builder is a supplied software tool that can be used to perform the
following operations:
•
•
•
•
Figure 2-5
Workspace is divided into three window panes:
Project Navigator
The window pane on the left side of the Workspace is where the Project Navigator
resides. The navigator consists of created project folders and the script files (.tsp)
created for each project. Each project folder can have one or more script files.
The navigator shown in
one named "SourceMeasure." As shown, the "BeeperTest" project has one script
file, and the "SourceMeasure" project has three script files.
Script Editor
The script chunk is written and/or modified in the Script Editor. Notice that there is
a tab available for each opened script file. A script project is then downloaded to
the SourceMeter where it can be run.
Programming Interaction
Up to seven tabs can be displayed in the lower window pane of the Workspace to
provide programming interaction between the Test Script Builder and the
SourceMeter. The Instrument Console (shown open in
commands to the connected SourceMeter. Retrieved data (e.g., readings) from
commands and scripts appear in the Instrument Console. See
interaction
Send ICL commands and TSL statements
Receive responses (data) to commands and scripts
Run factory scripts
Create and run user scripts
shows an example of the Test Script Builder. As shown, the
Figure 2-5
tabs" later in Section 2 for details on using the other tabs.
Return to
reset
has two projects; one named "BeeperTest" and
Section 2 topics 2600S-901-01 Rev. A / May 2006
or *RST) is sent.
Figure 2-5) is used to send
"Programming