Keithley SourceMeter 2600 Series Reference Manual page 34

1-8 Getting Started
1 Special keys and power switch:
DISPLAY
CONFIG
POWER
Number Keys The Number Keys (0-9, +/-, 0000) allow direct numeric entry in the EDIT
2 Source-measure setup, performance control and special operation:
Top Row – Source-measure setup
Models 2601, 2602, 2611, and 2612:
SRC
MEAS
LIMIT
MODE
Models 2602 and 2612 only:
SRC
MEAS
LIMIT
MODE
Middle Row
Models 2601, 2602, 2611, and 2612:
DIGITS
SPEED
REL
FILTER
Models 2602 and 2612 only:
DIGITS
SPEED
REL
FILTER
2600S-901-01 Rev. A / May 2006
Series 2600 System SourceMeters Reference Manual
Toggles between the various source-measure displays and the user
message mode. Selects Model 2602/2612 single or dual-channel display.
Use to configure a function or operation.
Power switch – In position turns SourceMeter on (I), out position turns it
off (O).
mode.
Channel A – Selects the source function (V or A) and places cursor in the
source field for editing.
Channel A – Cycles through measure functions (V, A, Ω or W).
Channel A – Places the cursor in the compliance limit field for editing.
Channel A – Directly chooses the measurement function (V, A, Ω or W).
Channel B – Selects the source function (V or A) and places cursor in the
source field.
Channel B – Cycles through measure functions (V,A, Ω or W).
Channel B – Places the cursor in the compliance limit field for editing.
Channel B – Directly chooses the measurement function (V, A, Ω or W).
Channel A – Changes resolution display to 4-1/2, 5-1/2, or 6-1/2 digits.
Channel A – Sets the measurement speed by controlling the A/D
converter measurement aperture.
Channel A – Controls relative, which allows a baseline value to be
subtracted from a reading.
Channel A – Controls the digital filter, which can be used to reduce
reading noise.
Channel B – Changes resolution display to 4-1/2, 5-1/2, or 6-1/2 digits.
Channel B – Sets the measurement speed by controlling the A/D
converter measurement aperture.
Channel B – Controls relative, which allows a baseline value to be
subtracted from a reading.
Channel B – Controls the digital filter, which can be used to reduce
reading noise.
Return to Section 1 topics