Keithley SourceMeter 2600 Series Reference Manual page 407

Series 2600 System SourceMeters Reference Manual
tsplink function and attributes
The function and attributes in this group are used to assign node numbers to Series 2600
instruments and initialize the TSP-Link system.
tsplink.node
Attribute TSP-Link node number.
Usage
mynode = tsplink.node
tsplink.node = mynode
mynode
• This attribute sets the TSP-Link node number and saves the value in non-volatile
Remarks
memory.
• After changing the node number, it will not take effect until the next time
tsplink.reset
• Each node connected to the TSP-Link must be assigned a different node number.
Details See Section 9
Also see tsplink.reset,
Sets the TSP-Link node to number 2:
Example
tsplink.node = 2
tsplink.reset
Function Initializes (resets) all nodes (instruments) in the TSP-Link system.
Usage
tsplink.reset()
This function will erase all knowledge of other nodes connected on the TSP-Link and
Remarks
will regenerate the system configuration. This function must be called at least once
before any remote nodes can be accessed. If the node number for any instrument is
changed, the TSP-Link must again be initialized.
Details See Section 9
tsplink.node,
Also see
tsplink.state
Attribute TSP-Link on-line state.
Usage
state = tsplink.state
Set node number from 1 to 64.
is executed on any node in the system.
(system expansion).
tsplink.state
(system expansion).
tsplink.state
Return to Section 12 topics
Instrument Control Library 12-133
-- Reads the node number.
-- Writes the node number.
2600S-901-01 Rev. A / May 2006