Keithley SourceMeter 2600 Series Reference Manual page 427

Series 2600 System SourceMeters Reference Manual
TSP Project Name:
TSP Test Script Name:
Firmware Version:
Function:
ConfigPulseVMeasureI
Usage:
f, msg = ConfigPulseVMeasureI
(smu,bias,level,limit,ton,toff,points,buffer,tag[,sync_in][,sync_out])
Description: Configures a voltage pulse train with a current measurement at each point.
Parameters:
KIFactoryPulse
KIPulse
1.2.0 and later
Measurement(s) will be made at the end of the ton time. This function does
not cause the specified smu to output a pulse train. It simply checks to see if
all of the pulse dimensions are achievable and if so, assigns the indicated
tag or index to the pulse train. The InitPulseTest(tag) and
InitPulseTestDual(tag) functions are used to initiate a pulse train
assigned to a valid tag.
smu,bias,level,limit,ton,toff,points,buffer,tag[,sync_in]
[,sync_out]
SourceMeter channel. (e.g. smua).
smu:
Pulse bias level in volts.
bias:
Pulse level in volts.
level:
Current limit (i.e. compliance) in amps.
limit:
Pulse width (i.e. on-time) in seconds.
ton:
Pulse off time in seconds.
toff:
Number of pulse measure cycles.
points:
Reading buffer where pulsed measurements will be stored. If
buffer:
this is nil when the function is called, no measurements will
be made when the pulse train is initiated.
Numeric identifier to be assigned to the defined pulse train.
tag:
Defines a digital IO trigger input line. If programmed, the pulse
sync_in:
train will wait for a trigger input before executing each pulse.
This parameter is optional.
sync_out: Defines a digital IO trigger output line. If programmed, the pulse
train will generate a trigger output immediately prior to the start
of ton. This parameter is optional.
Return to Section 13 topics 2600S-901-01 Rev. A / May 2006
Factory Scripts 13-17