Keithley SourceMeter 2600 Series Reference Manual page 414

13-4 Factory Scripts
TSP Project Name:
TSP Test Script Name:
Firmware Version:
Function:
PulseVMeasureI(smu, bias, level, ton, toff, points)
Description: Performs a specified number of pulse V, measure I cycles:
Parameters:
Data: Pulsed current measurements, voltage levels and timestamps are stored in
Example:
2600S-901-01 Rev. A / May 2006
Series 2600 System SourceMeters Reference Manual
KIFactoryGeneral
KIGeneral
1.0.2 and later
• Sets the to output
smu
• Sets the to output
smu
• Performs current measurement with source at
• Sets the to output
smu
• Repeats the above sequence for
level
bias
ton ton
smu, bias, level, ton, toff, points
SourceMeter Channel (A or B). Defaults to smua if all parameters
smu:
are omitted when function is called.
Bias level in volts.
bias:
Pulse level in volts.
level:
Pulse on-time in seconds.
ton:
Pulse off-time in seconds.
toff:
Number of pulse-measure cycles.
points:
.
smuX.nvbuffer1
PulseVMeasureI(smub, -1, 1, 1E-3, 2E-3, 20)
SMU B will output -1V and dwell for 1ms, output 1V and dwell for 2ms, and
then perform a current measurement. After the measurement, the output will
return to -1V and dwell for 2ms. This pulse-measure process will repeat 19
more times.
Return to
volts and dwell for
bias
volts and dwell for
level
volts for seconds.
bias toff
pulse-measure cycles.
points
bias
toff
Section 13 topics
seconds.
ton
seconds.
ton
amps.
level