Keithley SourceMeter 2600 Series Reference Manual page 591

Model No. ______________ Serial No. __________________Date ________________
Name and Telephone No. _________________________________________________
Company ______________________________________________________________
List all control settings, describe problem and check boxes that apply to problem. _________________________
__________________________________________________________________________________________
__________________________________________________________________________________________
❑ Intermittent
❑ IEEE failure
❑ Front panel operational ❑ All ranges or functions are bad
Display or output (check one)
❑ Drifts
❑ Overload
❑ Calibration only
(attach any additional sheets as necessary)
Show a block diagram of your measurement including all instruments connected (whether power is turned on or
not). Also, describe signal source.
Where is the measurement being performed? (factory, controlled laboratory, out-of-doors, etc.) ______________
__________________________________________________________________________________________
What power line voltage is used? ___________________ Ambient temperature? ________________________ °F
Relative humidity? ___________________________________________ Other? ___________________________
Any additional information. (If special modifications have been made by the user, please describe.)
__________________________________________________________________________________________
__________________________________________________________________________________________
Be sure to include your name and phone number on this service form.
Service Form
❑ Analog output follows display
❑ Obvious problem on power-up
❑ Unable to zero
❑ Will not read applied input
❑ Certificate of calibration required
❑ Particular range or function bad; specify
_______________________________
❑ Batteries and fuses are OK
❑ Checked all cables
❑ Unstable
❑ Data required