Keithley SourceMeter 2600 Series Reference Manual page 524

C-2 Common Commands
Introduction
This appendix includes information on common commands and their script
command equivalents.
Common commands
Command summary
Common commands supported by the Series 2600 SourceMeter are summarized
in Table
are not case sensitive, and either upper or lower case can be used. Note that
although these commands are essentially the same as those defined by the IEEE-
488.2 standard, the Series 2600 does not strictly adhere to that standard.
Table C-1
Common commands
Mnemonic
*CLS Clear status
*ESE <mask> Event enable command
*ESE? Event enable query
*ESR? Event status register query
*IDN? Identification query
*OPC Operation complete command
*OPC? Operation complete query
*RST Reset command
*SRE <mask> Service request enable
command
*SRE? Service request enable query
*STB? Status byte query
*TRG Trigger command
*TST? Self-test query
*WAI Wait-to-continue command
1. Status commands are covered in
2600S-901-01 Rev. A / May 2006
C-1. Although commands are shown in upper-case, common commands
Name
Appendix D.
Return to
Series 2600 System SourceMeters Reference Manual
Description
Clears all event registers and Error Queue.
Program the Standard Event Enable Register.
Read the Standard Event Enable Register.
Read/clear the Standard Event Enable Register.
Returns the manufacturer, model number, serial
number, and firmware revision levels of the unit.
Set the Operation Complete bit in the Standard
Event Register after all pending commands have
completed.
Places an ASCII "1" into the Output Queue when
all selected device operations have completed.
Returns the SourceMeter to default conditions.
Programs the Service Request Enable Register.
Reads the Service Request Enable Register.
Reads the Status Byte Register.
Sends a remote trigger to the SourceMeter.
Returns a 0.
Waits until all previous commands have
completed.
Appendix C topics
1
1
1
1
1
1
1