Keithley SourceMeter 2600 Series Reference Manual page 537

Series 2600 System SourceMeters Reference Manual
Table D-1 (cont.)
Status functions and registers
Type
System events
Clearing registers and queues
When the SourceMeter is turned on, various register status elements will be set
as follows:
•
•
•
•
•
•
Commands to reset the status registers and the Error Queue are listed in
2. In addition to these commands, any programmable register can be reset by send-
ing the 0 parameter value with the individual command to program the register.
Table D-2
Commands to reset registers and clear queues
To Reset Registers:
*CLS
or
status.reset()
To Clear Error Queue:
errorqueue.clear()
Function
status.system.enable
status.system2.enable
status.system3.enable
status.system4.enable
status.system5.enable
The PON bit in the status.condition register will be set.
Bits such as the output enable and over-temperature bits will be set
appropriately.
All enable registers will be set to 0.
All NTR registers will be set to 0.
All used PTR register bits will be set to 1.
The two queues will be empty.
Commands
Reset bits of status registers to 0.
Clear all messages from Error Queue.
Return to
1
Description
Appendix D topics 2600S-901-01 Rev. A / May 2006
Status Model D-9
Table D-