Keithley SourceMeter 2600 Series Reference Manual page 413

Series 2600 System SourceMeters Reference Manual
TSP Project Name:
TSP Test Script Name:
Firmware Version:
Function:
PulseIMeasureV(smu, bias, level, ton, toff, points)
Description: Performs a specified number of pulse I, measure V cycles:
Parameters:
Data: Pulsed voltage measurements, current levels and timestamps are stored in
Example:
KIFactoryGeneral
KIGeneral
1.0.2 and later
• Sets the to output
smu
• Sets the to output
smu
• Performs voltage measurement with source at
• Sets the to output
smu
• Repeats the above sequence for
level
bias
ton ton
smu, bias, level, ton, toff, points
SourceMeter Channel (A or B). Defaults to smua if all parameters
smu:
are omitted when function is called.
Bias level in amps.
bias:
Pulse level in amps.
level:
Pulse on-time in seconds.
ton:
Pulse off-time in seconds.
toff:
Number of pulse-measure cycles.
points:
.
smuX.nvbuffer1
PulseIMeasureV(smua, 0.001, 1.0, 20E-3, 40E-3, 10)
SMU A will output 1mA and dwell for 20ms, output 1A and dwell for 20ms,
and then perform a voltage measurement. After the measurement, the output
will return to 1mA and dwell for 40ms. This pulse-measure process will repeat
9 more times.
Return to
amps and dwell for
bias
amps and dwell for
level
amps for seconds.
bias toff
pulse-measure cycles.
points
bias
toff
Section 13 topics 2600S-901-01 Rev. A / May 2006
Factory Scripts 13-3
seconds.
ton
seconds.
ton
amps.
level