Keithley SourceMeter 2600 Series Reference Manual page 521

Series 2600 System SourceMeters Reference Manual
Table B-2 (cont.)
Error summary
Error number
5014 SERIOUS
5015 SERIOUS
5016 SERIOUS
5017 SERIOUS
5018 SERIOUS
5019 SERIOUS
5021 SERIOUS
5022 SERIOUS
5023 SERIOUS
5024 SERIOUS
5025 SERIOUS
5027 SERIOUS
5028 SERIOUS
5029 SERIOUS
5032 RECOVERABLE
5033 RECOVERABLE
5038 RECOVERABLE
5040 RECOVERABLE
5041 SERIOUS
5042 SERIOUS
5043 SERIOUS
5044 SERIOUS
5045 SERIOUS
5046 SERIOUS
5047 RECOVERABLE
5048 SERIOUS
5049 SERIOUS
5050 SERIOUS
Error level
Cannot restore cal data - unlock before restore
Save to cal set disallowed
Cannot change cal date - unlock before operation
Cannot change cal constants - unlock before operation
Cal version inconsistency
Cannot unlock - invalid password
Cannot restore default calset. Using previous calset
Cannot restore previous calset. Using factory calset
Cannot restore factory calset. Using nominal calset
Cannot restore nominal calset. Using firmware defaults
Cannot set filtercount > 1 when measure.count > 1
Unlock cal data with factory password
Cannot perform requested operation while source autorange
is enabled
Cannot save without changing cal date and cal due values
Cannot change this setting unless buffer is cleared
Reading buffer not found within device
Index exceeds maximum reading
Cannot use same reading buffer for multiple overlapped
measurements
Output Enable not asserted
Invalid while overlapped measure
Cannot perform requested operation while voltage measure
autorange is enabled
Cannot perform requested operation while current measure
autorange is enabled
Cannot perform requested operation while filter is enabled
SMU too hot
Minimum timestamp resolution is 1µs
Contact check not valid with HIGH-Z output off
Contact check not valid while an active current source
I limit too low for contact check
Return to
Error and Status Messages
Error Message
Appendix B topics 2600S-901-01 Rev. A / May 2006
B-7