Keithley SourceMeter 2600 Series Reference Manual page 421

Series 2600 System SourceMeters Reference Manual
TSP Project Name:
TSP Test Script Name:
Firmware Version:
Function:
SweepIListMeasureV(smu, ilist, stime, points)
Description: Performs a current list sweep with voltage measured at every step (point):
Parameters:
Data: Voltage measurements, current source values and timestamps are stored in
Example:
KIFactoryGeneral
KIGeneral
1.0.2 and later
• Sets the to output the first
smu
settle for seconds and then performs a voltage measurement.
stime
• Sets the to output the next
smu
settle for seconds and then performs a voltage measurement.
stime
• Repeats the above sequence until the voltage is measured for the last
amps value. The last point in the list to be measured is
smu, ilist, stime, points
SourceMeter Channel (A or B). Defaults to smua if all parameters
smu:
are omitted when function is called.
Arbitrary list of current source values:
ilist:
ilist = {value1, value2, ....valueN}
Settling time in seconds. Occurs after sourcing a value and before
stime:
performing a measurement.
Number of sweep measure points (must be
points:
.
smuX.nvbuffer1
myilist = {-100E-9, 100E-9, -1E-6, 1E-6, -1E-3, 1E-3}
SweepIListMeasureV(smua, myilist, 500E-6, 6)
This function performs a 6-point current list sweep starting at the first point in
. Voltage is measured at every step (point) in the sweep. The source
myilist
will be allowed to settle on each value for 500µs before a measurement is
performed.
Return to
amps value, allows the source to
ilist
amps value, allows the source to
ilist
Section 13 topics 2600S-901-01 Rev. A / May 2006
Factory Scripts 13-11
.
points
≥ 2).