Table of Contents
Advertisement
Warning:
working with hazardous materials. Consult the Safety Data Sheets regarding the
solvents you use. Additionally, consult the safety representative for your organization
regarding its protocols for handling such materials.
Warning:
The components within are not user-serviceable.
Warning:
Standby mode before beginning maintenance procedures.
Warning:
source; these components can be hot.
Warning:
enclosure open if one or both of these conditions apply:
• An ESI probe is fitted (the probe's tip is sharp).
• A corona pin is fitted (the pin's tip is sharp).
Notice:
following criteria are met:
• Instrument is in Standby mode.
• LC flow is diverted to waste or set to Off.
• Desolvation gas is turned off.
Warning:
reservoir bottles directly atop an instrument or device or on its front ledge. Instead,
place the bottles in the bottle tray, which serves as secondary containment in the event
of spills.
See
Safety Advisories (Page 169)
5.4 Preparing the instrument for working on the source
For safety reasons, you must follow this procedure before working on the source (for example,
when changing the probe or operating the source isolation valve), and when maintaining the
source.
Follow the procedure for the software that controls your mass spectrometer.
Observe Good Laboratory Practice (GLP) at all times, particularly when
To avoid electric shock, do not remove protective panels from the device.
To avoid harmless, static-like electric shock, ensure that the instrument is in
To avoid burn injuries, take great care while working with the probe and
To avoid puncture wounds, take great care while working with the source
When performing maintenance inside the source enclosure, ensure that the
To avoid equipment damage caused by spilled solvent, do not place
for safety advisory information.
March 17, 2021, 715005046 Ver. 03
Page 53
Advertisement
Table of Contents
