Spare Parts; Safety And Handling - Waters Vion IMS QTof Overview And Maintenance Manual

Table 5–1: Maintenance schedule (continued)
Procedure
Replace the NanoLockSpray
probe capillary.
Clean or replace the corona
pin (APCI modes).
Replace the IonSABRE II
probe heater.
Replace the ion block heater
cartridge.
Replace the source assembly
seals.
Replace the fluidics tubing.

5.2 Spare parts

Waters recommends that you replace only the parts mentioned in this document. For spare parts
details, see the Waters Quality Parts Locator on the Waters Web site's Services & Support page
(http://www.waters.com/waters/en_US/Spare-Parts/nav.htm?cid=511444).

5.3 Safety and handling

Adhere to the following safety considerations when performing maintenance procedures:
Warning:
To avoid personal contamination with biologically hazardous, toxic, or corrosive
materials, wear clean, chemical-resistant, powder-free gloves when working with the LC system
connections, probe and source components.
Frequency
Annually.
When the corona pin is
corroded or blackened, or the
sensitivity decreases to
unacceptable levels.
If the heater fails to heat the
probe.
If the heater fails to heat the
ion block.
Annually.
In the event of blockage in the
tubing connections between
the IntelliStart fluidics system
components.
March 17, 2021, 715005046 Ver. 03
Page 52
For information
See Replacing the
NanoLockSpray reference
probe capillary (Page 133).
See Cleaning or replacing the
corona pin (Page 117).
See Replacing the IonSABRE
II probe heater (Page 137).
See Replacing the ion block
source heater (Page 140).
See Replacing the LockSpray
source's assembly seals (Page
143).
See Replacing the fluidics
tubing (Page 147).