Table of Contents
Advertisement
Figure B–12: Signal connections
Connector
Signal cable
3. Slide the clamp (with the bend facing down) into the protective shield.
4. Insert the clamp and shield (with the bend facing down) into the connection cover, and
loosely tighten with one self-tapping screw.
Figure B–13: Inserting the clamp and shield
Clamp
Shield
Connection cover
5. Insert the connector with the signal cable into the connection cover, position the clamp
over the cable leads, and tighten the clamp into place with the second self-tapping screw.
March 17, 2021, 715005046 Ver. 03
Page 195
Advertisement
Table of Contents
