Saving A New Configuration File; Loading The Factory Default Configuration - Intermec Janus 2050 User Manual

JANUS 2050 Vehicle-Mount Computer User's Manual (4MB)
4-12

Saving a New Configuration File

If you modified your configuration or loaded a new file, you can save the
current configuration under a new filename by typing this command at the
DOS prompt:
ic /s { path\filename }
When you type this command, the JANUS 2050 checks to see if the filename
already exists. If it does, this prompt appears:
Overwrite (Yes/No)? N
Choose your response:
• Press N or e if you do not want to overwrite the file. The changes stay in
effect only until the JANUS 2050 is powered off or rebooted.
• Press Y to overwrite the contents of the file with your changes.
As the JANUS 2050 saves the changes, it displays this message:
Saving Reader
Configuration to
{ path\filename }
The JANUS 2050's configuration is now saved to the specified file.

Loading the Factory Default Configuration

You can load the factory default configuration without rebooting by typing this
command at the DOS prompt:
ic /d
39 nugget 39
nugget A
A