Using The Ata Card - Intermec Janus 2050 User Manual

4. If your ATA card is 4MB or less, press Y . If your ATA card is greater than
4MB, press N . ATAINIT begins initializing the card and displays these
messages.
Partition table successfully written.
BPB Boot sector successfully wiped.
Proceed with a DOS "FORMAT" command.
5. Type this command and press e :
format { drive: }
where drive: is the PC card drive.
Caution
Make sure you enter the correct drive letter when you format the ATA
card or you may erase the wrong drive.
CAUTION
Conseil
Assurez-vous de ne pas faire d'erreur en tapant la lettre identifiant le
lecteur pour le formatage de la carte ATA. Sinon, vous risquez d'effacer
un lecteur incorrect.
The program displays the next message.
WARNING: ALL DATA ON NON-REMOVABLE DISK
DRIVE G: WILL BE LOST!
Proceed with format (Y/N)?
6. Press Y to continue. When the card is formatted, the next prompt is
displayed.
Volume label (11 characters, ENTER for none)?
7. Press e if you do not want to enter a label for the card, or type a label
name (up to 11 characters long) and press e . The program displays the
card's capacity and other drive statistics. You are ready to use the ATA
card.

Using the ATA Card

You can use standard DOS commands to copy, delete, and move files, and to
create and remove directories on an ATA card. If you need more information
about DOS commands, refer to any book that describes DOS commands.
39 nugget A Using PC Cards
5
5-11